|
To complete this project you will need a pair of scissors and school glue. |
1) Cut a 3"x3"x3" flap on bottom of piņata, as close to center as possible. Perforate two small holes in middle of flap. |
 |
 |
|
2) From the inside, attach the piņata trap activator to flap, bring ribbon out of piņata. |
3) Close flap making sure ribbon is left out. Do not secure flap with any tape or adhesive. |
 |
 |
|
4) Using scotch or masking tape, attach each ribbon around base of piņata, pull the ribbon that is hanging out of trap and bring it to same level as other ribbons. |
5) Spread school glue over the bottom of the piņata. Apply the tissue paper provided in kit making sure that all ribbons are completely covered. Apply a second layer of tissue around edges of trap. Let dry. |
 |
|
Shopping Cart
